In electrochemistry, the Randles–Ševčík equation describes the effect of scan rate on the peak current for a cyclic voltammetry experiment. For simple redox events where the reaction is electrochemically reversible, and the products and reactants are both soluble, such as the ferrocene/ferrocenium couple, depends not only on the concentration and diffusional properties of the electroactive species but also on scan rate.[1]
ip=0.4463 nFAC\left(
| nFvD | |
| RT |
| ||||
| \right) |
Or if the solution is at 25 °C:[2]
ip=2.69 x 105 n3/2AC\sqrt{Dv}
For novices in electrochemistry, the predictions of this equation appear counter-intuitive, i.e. that increases at faster voltage scan rates. It is important to remember that current, i, is charge (or electrons passed) per unit time. In cyclic voltammetry, the current passing through the electrode is limited by the diffusion of species to the electrode surface. This diffusion flux is influenced by the concentration gradient near the electrode. The concentration gradient, in turn, is affected by the concentration of species at the electrode, and how fast the species can diffuse through solution. By changing the cell voltage, the concentration of the species at the electrode surface is also changed, as set by the Nernst equation. Therefore, a faster voltage sweep causes a larger concentration gradient near the electrode, resulting in a higher current.
This equation is derived using the following governing equations and initial/boundary conditions:
| \partialCO | |
| \partialt |
=-DO
| |||||||||
| \partialx2 |
CO(x,0)=
| * | |
| C | |
| O |
\limxCO(x,t)=
| * | |
| C | |
| O |
| \partialCR | |
| \partialt |
=-DR
| |||||||||
| \partialx2 |
CR(x,0)=
| * | |
| C | |
| R |
\limxCR(x,t)=
| * | |
| C | |
| R |
DO\left(
| \partialCO | |
| \partialx |
\right)x=0+DR\left(
| \partialCR | |
| \partialx |
\right)x=0=0
E=Ei+vt=E0'+
| RT | |
| nF |
ln\left(
| CO(0,t) | |
| CR(0,t) |
\right)
x
t
E
Ei
E0'
O
R
Using the relationships defined by this equation, the diffusion coefficient of the electroactive species can be determined. Linear plots of ip vs. ν1/2 and peak potentials (Ep) that are not dependent on ν provide evidence for an electrochemically reversible redox process. For species where the diffusion coefficient is known (or can be estimated), the slope of the plot of ip vs. ν1/2 provides information into the stoichiometry of the redox process, the concentration of the analyte, the area of the electrode, etc.
A more general investigation method is the plot of the peak currents as function of the scan rate on a logarithmically scaled x-axis. Deviations become easily detectable and the more general fit formula
| ox,red | |
| j | |
| max |
=j0+A ⋅ (
| scanrate | |
| mV/s |
)x
can be used.
In this equation
j0{}
E0
j0{}
j0{}
j0<<A
An example for this kind of reaction mechanism is the redox reaction of
| Fe3+/Fe2+ |
| KNO3 |
A more detailed plot with all fit parameters can be seen here.
